TM5-6115-640-14&P
Section XVI. BRACKETS/HOLDERS/SUPPORTS AND GROUND STUD MAINTENANCE
4-27. FUEL CAN BRACKET REPLACEMENT.
This task covers:
1. Removal
2. Installation
Initial Setup:
1.
Tools - General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Fuel Can Bracket (96906); MS53052-1
WARNING
Before performing any maintenance that requires climbing on or under trailer, set trailer
handbrakes, chock both wheels, and lower rear leg prop. Injury to personnel could result from
trailer suddenly rolling or tipping.
There are two fuel can brackets supplied with the AN/MJQ-32 and four fuel can brackets supplied with the AN/MJQ-33.
One bracket on the AN/MJQ-32 is mounted on each fender extension; one, roadside rear, near the switch box; the other,
curbside front, facing front of generator. Two brackets on the AN/MJQ-33 are mounted on each side of the front
generator; the other two are mounted in front of accessory box. Replacement procedures described below are typical for
both power plant brackets. The AN/MJQ-33 power plant is shown.
a.
Removal.
(1)
Remove four screws (1, figure 4-14), nuts (2), and flat washers (3) securing bracket (4) to fender extension
(AN/MJQ-32) or bed (AN/MJQ-33).
(2)
Remove fuel can bracket (4) from fender extension or bed.
b.
Installation.
(1)
Position fuel can bracket (4) on fender extension (AN/MJQ-32) or bed (AN/MJQ-33).
4-47
