TM5-6115-640-14&P
Section XV. STOWAGE RACK MAINTENANCE
4-26. STOWAGE RACK MAINTENANCE, AN/MJQ-32 ONLY.
This task covers:
1. Repair
3. Installation
2. Removal
Initial Setup:
1.
Tools - General Mechanics Tool Kit (5180-00-177-7033)
- Drill, 1/4-inch (5130-00-807-3009)
2.
Materials/Parts - Rack Assembly (97403); 13228E9902
- Clamps (97403); 13205E5137-2
- Runners (97403); 13205E5120, 13205E5121, 13025E5123
- Strap Fastener (97403); 13218E5091
- Rivets (96906); MS9460-102
a.
Repair. (See figure 4-13). Repair of the rack assembly is limited to replacement of clamps, runners, and strap
fasteners. If required, repaint in accordance with MIL-T-704 and MIL-C-46168. Replacement is as follows:
(1)
Clamps.
(a)
Remove two nuts (6, figure 4-13), flat washers (7), and screws (8) from either one of two each leaf-butt
hinges (9). Remove leaf-butt hinge.
(b)
Slide clamp (10) out of remaining leaf-butt hinge.
(c)
Place new clamp (10) into remaining leaf-butt hinge and slide removed leaf-butt hinge (9) on clamp.
(d)
Position leaf-butt hinge on rack and secure with two screws (8), flat washers (7), and nuts (6).
4-44
