TM5-6115-640-14&P
b.
Removal.
(1)
Loosen strapping (11, figure 4-16) and remove from cable reel (14).
(2)
Remove cable-reel from bracket (13) by loosening hold-down assembly (15) and removing assembly. Remove
sleeving (16) from inside of cable reel.
(3)
Remove four locknuts (17), flat washers (18), and screws (19) securing bracket (13) to rear fender extension
(20).
(4)
Remove cable-reel bracket from rear fender extension.
c.
Installation.
(1)
Position cable-reel bracket (13) on rear fender extension (20).
(2)
Insert four screws (19) down through the bracket and through rear fender extension.
(3)
Install one washer (18) and locknut (17) on each screw (19). Tighten hardware to secure bracket.
(4)
Place sleeving (16) inside cable reel (14).
(5)
Install cable reel on bracket (13) and slide hold-down assembly (15) through reel and bracket and tighten.
(6)
Secure cable reel (14) by tightening strapping (11).
4-32. SPOUT, CAN, HOLDER REPLACEMENT, AN/MJQ-32 ONLY.
This task covers:
1. Removal
2. Installation
Initial Setup:
1.
Tools - General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Spout Holder (97403); 13212E3553-2
4-53
