TM5-6115-640-14&P
b.
Installation.
(1)
Position holder (29) on curbside section of rear fender extension (20).
(2)
Insert two screws (28) through holder and rear fender extension.
(3)
Install one flat washer (27), locknut (26) on each screw. Tighten hardware to secure holder.
4-34. HAMMER BRACKET ASSEMBLY REPLACEMENT, AN/MJQ-32 ONLY.
This task covers:
1. Removal
2. Installation
Initial Setup:
1.
Tools - General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Hammer Bracket (97403); 13212E3553-1
The hammer bracket assembly is located at the rear of the trailer.
a.
Removal.
(1)
Loosen the two wingnuts (1, figure 4-17) which hold bracket plate (2) in place and allow bracket plate to swing
downward.
(2)
Remove locknut (3), two flat washers (4), and screw (5) securing bracket assembly (6) to rear chassis (7).
(3)
Remove bracket assembly from rear chassis.
b.
Installation.
(1)
Position bracket assembly (6) on rear chassis (7).
(2)
Insert screw (5) and flat washer (4) through bracket assembly and chassis.
(3)
Install flat washer (4) and locknut (3) on bolt. Tighten hardware to secure bracket assembly.
(4)
Rotate bracket assembly plate (2) to upright position and tighten wingnuts (1).
4-55
