TM5-6115-640-14&P
b.
Installation.
(1)
Position bracket assembly (6) on front chassis (7).
(2)
Insert two screws (5) and two flat washers (4) through bracket assembly (6) and front chassis (7).
(3)
Install flat washer (4) and locknut (3) on each screw (5). Tighten hardware to secure bracket assembly (6).
(4)
Rotate bracket assembly plate (2) to upright position and secure by tightening wingnuts (1).
4-36. DRIVER/PULLER HOLDER REPLACEMENT, AN/MJQ-32 ONLY.
This task covers:
1. Removal
2. Installation
Initial Setup:
1.
Tools - General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Driver/Puller Holder (97403); 13228E9898
The driver/puller holder is located on roadside front fender extension.
a.
Removal.
(1)
Remove two locknuts (1, figure 4-19), four flat washers (2), and two screws (3) securing holder (4) to front fender
extension (5).
(2)
Remove holder from front fender extension.
b.
Installation.
(1)
Position holder (4) on front fender extension (5).
(2)
Insert two screws (3) and two flat washers (2) through holder (4) and front fender extension (5).
(3)
Install flat washer (2) and locknut (1) on each screw (3). Tighten hardware to secure holder.
4-58
