TM 5-6115-640-14&P
(d)
Remove spout, can, holder (paragraph 4-31a).
(e)
Remove antenna mast mount (paragraph 4-29a).
(f)
Remove fuel can bracket (paragraph 4-27a).
(g)
Remove power cable brackets (paragraph 4-38a).
(h)
Remove 5 locknuts (1, figure 5-5), 10 flat washers (2), and 5 screws (3) securing inner edge of
curbside fender/fender extension (15) to trailer frame (13).
(i)
Remove four locknuts (4), eight flat washers (5), and four screws (6) securing cross braces (14) to
curbside fender/ fender extension.
(j)
Remove four locknuts (7), eight flat washers (8), and four screws (9) securing center portion of
curbside fender/fender extension to trailer frame (13).
(k)
Remove 6 locknuts (10), 12 flat washers (11), and 6 screws (12) securing remainder of curbside
fender/fender extensions to trailer frame.
(l)
Remove curbside fender/fender extension from trailer frame.
(2)
Removal (Roadside).
(a)
Remove stowage rack (paragraph 4-26b(1)).
(b)
Remove antenna mast mount (paragraph 4-29a).
(c)
Remove driver/puller holder (paragraph 4-36a).
(d)
Remove fire extinguisher bracket (paragraph 4-28a).
(e)
Remove switchbox (paragraph 4-19c(1)) and bracket (paragraph 4-37a).
(f)
Remove power cable brackets (paragraph 4-38a).
(g)
Remove fuel can bracket (paragraph 4-27a).
(h)
Perform steps (h) thru (k) of Removal (Curbside), above, for roadside fender/fender extension (16).
(i)
Remove roadside fender/fender extension from trailer frame.
b.
Repair. Repair of the fender/fender extensions is limited to straightening, welding, or repainting. If required,
repaint in accordance with MIL-T-704 and MIL-C-46168.
5-12
