TM 5-6115-640-14&P
(2)
Disconnect all wires from switch (6) by removing screws (7) from each switch terminal.
(3)
Remove screw (8) securing knob (9) to switch (6) and take off knob.
(4)
Unscrew pin (10) from switch shaft.
(5)
Remove four screws (11), flat washers (12), and sealing washers (13) securing switch (6) to cover (4) and
remove switch from cover.
(6)
Remove sealing washer (14) from switch.
NOTE
Ensure that terminals B1 and B3 are facing upward when installing switch on cover.
b.
Installation.
(1)
Install sealing washer (14) on switch (6) and position switch on inside of cover (4). Install four sealing
washers (13), flat washers (12), and screws (11) securing switch to cover (4).
(2)
Screw pin (10) into switch shaft.
(3)
Position knob (9) on switch (6) and install screw (8).
NOTE
Observe identification bands on wires when reconnecting wires.
(4)
Connect indicator light wires to switch (paragraph 4-23d).
(5)
Connect power cables to switch (paragraph 4-24b(2)).
(6)
Connect load terminal wires to switch (paragraph 4-22b(2)).
(7)
Position cover (4) on switch box (5) and secure with 16 flatwashers (3) lockwashers (2) and screws (1).
5-7
