TM 5-6115-640-14&P
5-11. TRAILER BED AND FENDER REPAIR AND REPLACEMENT AN/MJQ-33.
This task covers:
1. Removal
3. Installation
2. Repair
Initial Setup:
1.
Tools - General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Trailer Bed (97403); 13221E7326
a.
Removal. (See figure 5-6). The body of the modified AN/MJQ-33 trailer consists of a single weldment that
includes both fender and the bed of the trailer.
(1)
Remove tarpaulin (paragraph 3-6a(1)).
(2)
Remove tarpaulin support and bow assembly (paragraph 3-6b(1)).
(3)
Remove accessory box (paragraph 4-25a).
(4)
Remove switchbox (paragraph 4-19c(1)).
(5)
Remove generator sets (paragraph 5-5a).
(6)
Remove 10 screws (1, figure 5-6), 20 flat washers (2), and 10 nuts (3) securing trailer body (4) to trailer
chassis (5).
(7)
Remove 16 screws (6), 32 flat washers (7), and 16 nuts (8) securing trailer body (4) to trailer chassis (5).
NOTE
Removal of the trailer body requires the removal and disassembly of both handbrake lever
assemblies. The handbrake lever assemblies are symmetrical and this procedure is typical for
both.
(8)
Remove two screws (9), spacers (10), and nuts (11) and remove roadside handbrake lever assembly (12)
from trailer chassis (5).
(9)
Remove cotter pin (13), washer (14), shaft (15), and pulley (16) from handbrake lever assembly (12).
(10)
Working under trailer, pull handbrake cable clevis (17) back through the holes in the front two braces on
the trailer body.
(11)
Repeat steps (8) thru (10) to remove and disassemble curbside handbrake lever assembly.
5-15
