TM 5-6115-640-14&P
(9)
Assemble handbrake lever assembly (12) using two screws (9) and spacers (10). Make certain top screw
(9) goes through spacer (18) and bottom screw (9) goes through handbrake cable clevis.
(10)
Position assembled handbrake lever assembly (12) on trailer chassis (5) and install two nuts (11). Tighten
hardware.
(11)
Repeat steps (6) thru (10) to assemble and install curbside handbrake lever assembly.
(12)
Install generator set (paragraph 5-5b).
(13)
Install accessory box (paragraph 4-25b).
(14)
Install tarpaulin support and four bow assemblies (paragraph 3-6b(2).
(15)
Install tarpaulin (paragraph 3-6a2).
5-12. REAR LEG PROP ASSEMBLY REPAIR AND REPLACEMENT.
This task covers:
1. Removal
3. Installation
2. Repair
Initial Setup:
1.
Tools - General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Trailer Bed (97403); 13221E7326
Maintenance of the rear leg prop assembly consists of repairing or replacing the assembly as required. The rear leg prop
assembly is the same for both power plants.
a.
Leg Prop Assembly Removal. (See figure 5-7.)
(1)
While supporting rear leg prop assembly, pull out angled bar (1, figure 5-7) and lower the leg prop
assembly from its traveling position.
(2)
Line up boss (2) on upper leg (3) with holes in bracket (4) and insert angled bar (1) to lock leg in support
position.
(3)
Remove either one of two cotter pins (5) from leg prop assembly pivot shaft (6).
(4)
While steadying leg prop assembly, remove shaft (6) with remaining cotter pin (5) in place.
5-18
