TM 5-6115-640-14&P
(2)
Assembly.
(a)
Clamp upper leg (2) in vise with spring pin hole facing up.
(b)
Insert leg base (3) into upper leg and turn leg base until hole in screw lines up with hole in upper leg.
(c)
Install spring pin (1) to secure leg base to upper leg.
(d)
Install leg prop assembly on trailer (paragraph 5-12a(2)).
c.
Rear Leg Prop Assembly Installation.
(1)
Position bracket (4, figure 5-7) on trailer frame (15) and install two screws (7), four flat washers (8), two
lockwashers (9) and nuts (1U).
(2)
Install screw (11), flat washer (12), lockwasher (13), and nut (14). Tighten all hardware.
(3)
Lift rear leg prop assembly into bracket (4) and secure by inserting angled bar (1) through holes in bracket
and boss (2) on upper leg (3).
(4)
Position rear leg prop assembly to line up boss on top of leg with pivot holes in bracket (4). Insert pivot
shaft (6).
(5)
Insert cotter pin (5) in pivot shaft (6) and bend cotter pin legs in opposite directions.
(6)
Pull out angled bar (1) to unlock leg prop assembly.
(7)
Swing rear leg prop assembly up into traveling position and secure by inserting angled bar (1) through
holes in bracket (4) and boss (2) on upper leg (3).
5-13. TARPAULIN REPAIR, AN/MJQ-33 ONLY .
Repairs to the tarpaulin shall be made in accordance with FM10-16, Fabric Repairing.
5-21/(5-22 blank)
