TM 5-6115-628-14&P
Figure 4-9. Rear Steps Replacement.
(6) Install one flat washer (2) and one nut (3) on each screw (1) and tighten.
4-23.
Fender Replacement. (See figure 4-10.) The fenders on the trailer assemblies are
symmetrical, and replacement procedures are the same for all.
a. Removal.
(1) Remove five screws (1, figure 4-10), ten flat washers (2) and five nuts (3) securing
fender (4) to trailer frame (5).
WARNING
There are five sets of hardware securing fender to rear step and seven sets of
hardware securing fender to front step. This hardware should be removed in
sequence from trailer frame outward. In this way, last two screws on front and
rear lower fender edge will support fender until you are out from underneath.
(2) Remove six screws (6), 12 flat washers (7) and six nuts (8) securing fender (4) to front
step (9).
(3) Remove fours screws (10), eight flat washers (11) and four nuts (12) securing fender (4)
to rear step (13).
4-22
