TM 5-6115-628-14&P
WARNING
Support fender while removing remaining two screws. When screws are
removed, fender will drop.
(4) Remove one screw (6), two flat washers (7) and one nut (8) securing fender (4) to front
step (9).
(5) Remove one screw (10), two flat washers (11) and one nut (12) securing fender (4) to
rear step (13).
(6) Remove fender (4).
b. Installation.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Position fender (4) on trailer.
Insert one screw (10) with flat washer (11) through lower outside edge of fender (4) into
rear step (13), and insert one screw (6) with flat washer (7) through lower outside edge of
fender (4) into front step (9).
Install one washer (11) and one nut (12) on screw (10), and one washer (7) and one
nut (8) on screw (6). Tighten hardware.
Insert five screws (1) with flat washers (2) down through fender (4) into trailer frame (5).
Working under fender, install one flat washer (2) and one nut (3) on each screw (1) and
tighten.
Insert six screws (6) with flat washers (7) through fender (4) into front step (9). Install
one washer (7) and one nut (8) on each screw (6) and tighten.
Insert four screws (10) with flat washers (11) through fender (4) into rear step (13).
Install one washer (11) and one nut (12) on each screw (10) and tighten.
4-24.
Personnel Platform Replacement. (See figure 4-11). This platform is mounted on the rear of
each trailer to facilitate access to generator set controls and indicators.
a. Removal.
(1) Remove two screws (1, figure 4-11), four flat washers (2) and two nuts (3) securing
platform (4) to mounting brackets (5).
WARNING
Support platform while removing anchors. When anchors are removed,
platform will drop.
(2) Remove two platform anchors (6) by pushing in on button on head of pin while pulling pin
out of mounting hole.
4-24
