TB 9-6115-644-13
18.
Open output box door.
19.
Remove wire 172D from P6-18 of generator (generator wiring harness) and tie back wire with straps provided in kit.
20.
Remove pins from P6-16 and 24, Figure 5-7.
21.
Install wiring harness (2) in accordance with wiring diagram. Secure harness with straps contained in kit.
NOTE
Install fuse, (25 AMP, MAX 32V) in fuse holder, part of harness (2), if
not already installed.
22.
Connect 24V terminal wire from fuse holder (1) to the positive side of the slave receptacle, Figure 5-7, and the ground
wire to the negative side of the slave receptacle.
23.
Drill a 1/5" hole in the front housing in a visible location next to the slave receptacle and mount fuse holder (1) using
screw, flatwasher, lock washer, and nut provided in kit.
