TM 9-6115-729-24
0110
REMOVAL
1. Remove two screws (Figure 1, Item 1), eleven bolts (Figure 1, Item 2), front cover (Figure 1, Item 3), and
gasket (Figure 1, Item 4) from front housing (Figure 1, Item 5).
2. Remove two screws (Figure 1, Item 6), washers (Figure 1, Item 7), cover (Figure 1, Item 8), and seal
(Figure 1, Item 9).
END OF TASK
INSTALLATION
1. Install seal (Figure 1, Item 9), cover (Figure 1, Item 8), two washers (Figure 1, Item 7), and cover (Figure 1,
Item 6) on front cover (Figure 1, Item 3).
CAUTION
Front housing and front cover must be clean before installation of front cover.
2. Install gasket (Figure 1, Item 4) and front cover (Figure 1, Item 3) on front housing (Figure 1, Item 5) and
secure with eleven bolts (Figure 1, Item 2) and two screws (Figure 1, Item 1).
3. Torque two studs to 15-25 lb-ft (20-34 Nm).
4. Install crankshaft pulley and damper (WP 0104).
5. Install fan pulley (WP 0076).
0110-2
