TM 9-6115-729-24
0111
REMOVAL
1. Remove three screws (Figure 1, Item 1), two bolts (Figure 1, Item 2), five washers (Figure 1, Item 3), oil filter
base (Figure 1, Item 4), and three O-rings (Figure 1, Item 5).
WARNING
Oil filter base and housing springs are under tension and can act as projectiles when being
removed. Use eye protection when removing springs. Failure to comply can cause injury to
personnel.
2. Remove plug (Figure 1, Item 6), spring (Figure 1, Item 7), check valve (Figure 1, Item 8), and preformed
packing (Figure 1, Item 9).
3. Disconnect tube (Figure 1, Item 10) and remove O-ring (Figure 1, Item 11), elbow (Figure 1, Item 12), and
O-ring (Figure 1, Item 13) from oil cooler (Figure 1, Item 14).
4. Remove seven bolts (Figure 1, Item 15), two screws (Figure 1, Item 16), nine washers (Figure 1, Item 17), oil
cooler (Figure 1, Item 14), and gasket (Figure 1, Item 18).
5. Remove oil cooler core (Figure 1, Item 19), gasket (Figure 1, Item 20), and two O-rings (Figure 1, Item 21).
6. Remove plug (Figure 1, Item 22), spring (Figure 1, Item 23), check valve (Figure 1, Item 24), and preformed
packing (Figure 1, Item 25).
END OF TASK
INSTALLATION
WARNING
Oil filter base and housing springs are under tension and can act as projectiles when being
removed. Use eye protection when removing springs. Failure to comply can cause injury to
personnel.
NOTE
Apply light coat of engine oil to all O-rings and preformed packings before installation.
1. Install preformed packing (Figure 1, Item 25), check valve (Figure 1, Item 24), spring (Figure 1, Item 23), and
plug (Figure 1, Item 22).
2. Install two O-rings (Figure 1, Item 21), gasket (Figure 1, Item 20), and oil cooler core (Figure 1, Item 19).
3. Install gasket (Figure 1, Item 18), oil cooler (Figure 1, Item 14), nine washers (Figure 1, Item 17), two screws
(Figure 1, Item 16), and seven bolts (Figure 1, Item 15). Torque screws (Figure 1, Item 16) and bolts (Figure 1,
Item 15) to 15-25 lb-ft (20-34 Nm).
0111-2
