TM 9-6115-729-24
0112
REMOVAL
NOTE
Engine oil capacity is 30 quarts (27.3 L).
1. Place suitable container below oil drain valve (Figure 1, Item 1) at lower right side of oil pan (Figure 1, Item 2)
and allow oil to drain from system.
2. Remove 36 bolts (Figure 1, Item 3), washers (Figure 1, Item 4), and oil pan (Figure 1, Item 2). Scrape gasket
(Figure 1, Item 5) from oil pan (Figure 1, Item 2) or engine block.
3. Remove plug (Figure 1, Item 6), O-ring (Figure 1, Item 7), drain valve (Figure 1, Item 1), and O-ring (Figure 1,
Item 8).
4. Remove magnetic drain plug (Figure 1, Item 9) and preformed packing (Figure 1, Item 10). Inspect magnetic
drain plug (Figure 1, Item 9) for metal particles and wipe clean. Notify supervisor if particles are present.
END OF TASK
INSTALLATION
1. Install preformed packing (Figure 1, Item 10) and magnetic drain plug (Figure 1, Item 9).
2. Install O-ring (Figure 1, Item 8), drain valve (Figure 1, Item 1), O-ring (Figure 1, Item 7), and plug (Figure 1,
Item 6).
3. Apply thin coat of gasket cement between bolt holes only at four corners of oil pan (Figure 1, Item 2).
CAUTION
Do not get gasket cement on any part of engine block, gasket, or oil pan not specifically
designated.
4. Position gasket (Figure 1, Item 5) on oil pan (Figure 1, Item 2) and install oil pan (Figure 1, Item 2) on engine
block. Install four washers (Figure 1, Item 4) and bolts (Figure 1, Item 3) at locations marked "X" hand tight.
5. Install remaining 32 washers (Figure 1, Item 4) and bolts (Figure 1, Item 3). Tighten hand tight.
6. Beginning at the left rear corner (location marked "Z"), torque 36 bolts (Figure 1, Item 3) in a counterclockwise
pattern to 21-25 lb-ft (28-34 Nm). Re-torque 36 bolts (Figure 1, Item 3) in a counterclockwise pattern to 21-25
lb-ft (28-34 Nm).
7. Refill engine with oil (WP 0081).
8. Install engine (WP 0098).
0112-2
