TM 9-6115-729-24
UNIT (FIELD) LEVEL MAINTENANCE
TACTICAL QUIET GENERATOR 100 kW, 50/60 Hz MEP-807A/PU-807A
REAR SECTION HOUSING ASSEMBLY MAINTENANCE
INITIAL SETUP:
Tools and Special Tools
Equipment Condition
Tool Kit, General Mechanic's (WP 0119, Item 1)
Control box assembly removed (WP 0041)
Generator access cover assembly removed
Materials/Parts
Left rear door assembly (latch) removed (WP 0023)
Foam damping sheet (WP 0120, Item 11)
Right rear door assembly (latch) removed
Personnel Required
Winterization heater control box assembly removed,
if applicable (WP 0091)
One
Rear roof section housing assembly removed
References
Potential transformers PT2 and PT3 removed
TM 9-6115-729-24P
WARNINGS
Metal jewelry will conduct electricity. All jewelry can become entangled in generator set
components. Remove all jewelry when working on generator set. Failure to comply can cause
injury or death to personnel by electrocution.
DO NOT wear loose clothing when performing checks, services and maintenance. Failure to
comply can cause injury or death to personnel.
High voltage is produced when this generator set is in operation. Make sure unit is completely shut
down and free of any power source before attempting any repair or maintenance on the unit.
Failure to comply can cause injury or death to personnel.
High voltage is produced when the generator set is in operation. Never attempt to start or
maintain the generator set unless it is properly grounded. Failure to comply can cause injury or
death to personnel.
REMOVAL
1. Remove three screws (Figure 1, Item 1), lockwashers (Figure 1, Item 2), and washers (Figure 1, Item 3).
2. Remove two screws (Figure 1, Item 4), lockwasher (Figure 1, Item 5), and washer (Figure 1, Item 6).
3. Remove six screws (Figure 1, Item 7), lockwashers (Figure 1, Item 8), and washers Figure 1, Item 9).
4. Remove four screws (Figure 1, Item 10), lockwashers (Figure 1, Item 11), and washers (Figure 1, Item 12)
and rear section housing assembly (Figure 1, Item 13).
0034-1
