TM 9-6115-729-24
UNIT (FIELD) LEVEL MAINTENANCE
TACTICAL QUIET GENERATOR 100 kW, 50/60 Hz MEP-807A/PU-807A
FRONT SECTION HOUSING ASSEMBLY MAINTENANCE
INITIAL SETUP:
Tools and Special Tools
Equipment Condition
Tool Kit, General Mechanic's (WP 0119, Item 1)
Right battery access door assembly removed
Materials/Parts
Left battery access door assembly removed
Foam damping sheet (WP 0120, Item 11)
Front roof section housing removed (WP 0029)
Foam damping sheet (WP 0120, Item 12)
Engine generator compartment ceiling removed
Personnel Required
Right front door assembly (latch) removed
One
Left front door assembly (latch) removed
References
Batteries removed (WP 0049)
Battery disconnect switch removed
TM 9-6115-729-24P
Slave receptacle removed (WP 0053)
Winterization heater assembly removed, if
applicable (WP 0092)
WARNINGS
Metal jewelry will conduct electricity. All jewelry can become entangled in generator set
components. Remove all jewelry when working on generator set. Failure to comply can cause
injury or death to personnel by electrocution.
DO NOT wear loose clothing when performing checks, services and maintenance. Failure to
comply can cause injury or death to personnel.
High voltage is produced when this generator set is in operation. Make sure unit is completely shut
down and free of any power source before attempting any repair or maintenance on the unit.
Failure to comply can cause injury or death to personnel.
High voltage is produced when the generator set is in operation. Never attempt to start or
maintain the generator set unless it is properly grounded. Failure to comply can cause injury or
death to personnel.
REMOVAL
1.
Remove four screws (Figure 1, Sheet 1, Item 1), lockwashers (Figure 1, Sheet 1, Item 2), washers (Figure 1,
Sheet 1, Item 3), and nuts (Figure 1, Sheet 1, Item 4).
0033-1
