TM 9-6115-729-24
0035
DISASSEMBLY
1. Remove four screws (Figure 1, Item 11), lockwashers (Figure 1, Item 12), and washers (Figure 1, Item 13),
from duct (Figure 1, Item 14).
2. Remove four screws (Figure 1, Item 15), lockwashers (Figure 1, Item 16), and washers (Figure 1, Item 17),
and duct (Figure 1, Item 14).
3. Remove five foam damping sections if required.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sections as templates to cut new foam damping sections. Install five foam
damping sections.
2. Install duct (Figure 1, Item 14), and secure with four washers (Figure 1, Item 17), lockwashers (Figure 1, Item
16), and screws (Figure 1, Item 15).
3. Install four washers (Figure 1, Item 13), lockwashers (Figure 1, Item 12), and screws (Figure 1, Item 11).
END OF TASK
INSTALLATION
1. Install left center panel assembly (Figure 1, Item 3), and secure with four washers (Figure 1, Item 10),
lockwashers (Figure 1, Item 9), and screws (Figure 1, Item 8).
2. Install two washers (Figure 1, Item 20), lockwashers (Figure 1, Item 19), and screws (Figure 1, Item 18).
3. Install three washers (Figure 1, Item 7), lockwashers (Figure 1, Item 6), and screws (Figure 1, Item 5).
4. Connect fuel filler neck pocket (Figure 1, item 4) to left center panel assembly (Figure 1, Item 3) with ten
screws (Figure 1, item 2) and nuts (Figure 1, item 1).
END OF TASK
END OF WORK PACKAGE
0035-3/4 blank