TM 9-6115-729-24
0034
DISASSEMBLY
1. Remove four nuts (Figure 1, Item 14), washers (Figure 1, Item 15), screws (Figure 1, Item 16), lockring
(Figure 1, Item 17), bushing (Figure 1, Item 18), retainer plate (Figure 1, Item 19), spacer (Figure 1, Item 20),
and sleeve (Figure 1, Item 21).
2. Remove six foam damping sections as required.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sections as templates to cut new foam damping sections. Install six foam
damping sections.
2. Install sleeve (Figure 1, Item 21), spacer (Figure 1, Item 20), retainer plate (Figure 1, Item 19), bushing
(Figure 1, Item 18), lockring (Figure 1, Item 17), four screws (Figure 1, Item 16), washers (Figure 1, Item 15),
and nuts (Figure 1, Item 14).
END OF TASK
INSTALLATION
1. Install rear section housing assembly (Figure 1, Item 13).
2. Install four screws (Figure 1, Item 10), lockwashers (Figure 1, Item 11), and washers (Figure 1, Item 12) to
rear section housing assembly (Figure 1, Item 13).
3. Install six screws (Figure 1, Item 7), lockwashers (Figure 1, Item 8), and washers Figure 1, Item 9).
4. Install two screws (Figure 1, Item 4), lockwasher (Figure 1, Item 5), and washer (Figure 1, Item 6).
5. Install three screws (Figure 1, Item 1), lockwashers (Figure 1, Item 2), and washers (Figure 1, Item 3).
6. If removed, install winterization heater control box assembly (WP 0091).
7. Install generator access cover assembly (WP 0032).
8. Install control box assembly (WP 0041).
9. Install rear roof section housing assembly (WP 0030).
10. Install potential transformers PT2 and PT3 (WP 0052).
END OF TASK
END OF WORK PACKAGE
0034-3/4 blank
