ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
(c)
Resistance (ohms) readings should be high in one direction and low in the other. If readings
are high or low in both directions, diodes are defective and must be replaced.
(d)
Repeat steps a, b, and c for each set of diodes.
(2)
Using multimeter set for ohms, check for continuity between point A and brush B, between terminal C
and brush spring D, and between terminal E and connector F (Figure 5-44). Replace brush or brush
assembly as necessary if indications are other than stated.
(3)
Using multimeter set for ohms, check stator for open circuits between point G (laminations) and each
stator terminal (Figure 5-45). If continuity is noted between laminations and any terminal, stator is
defective and must be replaced.
(4)
Using multimeter set for ohms, check for continuity between all combinations of terminals A, B, and C.
Check for continuity between all combinations of terminals D, E, and F. Check for open circuits
between all combinations of terminals A, B, and C to terminals D, E, and F. Replace stator if
indications are other than stated.
