ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-199
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove coolant temperature sender, refer to paragraph 4.13.2. b.
__________
WARNING
Cleaning with compressed air can cause flying particles. When using
compressed air, wear protective glasses and use clean, low pressure air, less
than 30 psi (206.8 kPa). Failure to comply can cause eye injury.
__________
WARNING
Dry cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract.
Skin and eye protection are required when working in contact with dry
cleaning solvent. Avoid repeated or prolonged contact. Work in ventilated
area only. Failure to comply can cause injury or death to personnel.
(3)
Clean coolant temperature sender with dry, filtered compressed air, and wipe with a clean, lint-free
cloth (Item 8, Appendix E) lightly moistened with dry cleaning solvent (Item 20, Appendix E).
(4)
Inspect coolant temperature sender for cracked casing, stripped or damaged threads, corrosion, or
other damage.
(5)
Replace coolant temperature sender if damaged.
(6)
Install coolant temperature sender, 4.13.2.d.
d. Installation.
(1)
Apply sealing compound (Item 22, Appendix E) to threads of coolant temperature sender (2, Figure
4-30), and install switch on engine block.
(2)
Connect electrical plug connector to coolant temperature sender (2).
(3)
Add coolant/antifreeze to proper level at the filler neck (2, Figure 4-22).
(4)
Install radiator cap (1) on filler neck (2).
(5)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
(6)
Start generator set, paragraph 2.11.1. Allow unit to reach operating temperature, and check for
leaks.
(7)
Add coolant/antifreeze to overflow bottle as required.
(8)
Close engine compartment access doors.
