ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-203
(5)
Tag and remove wire number 310A16 (FO-1) from positive post of alternator by removing nut (4),
washer (5), terminal washer (6) and isolating washer (7).
(6)
Cut ring terminal (8) from wire number 310A16 and feed wire through the top of the battery current
transducer (1).
(7)
Tag and remove wire number 145C16 from the positive post of battery number one.
(8)
Cut ring terminal from wire number145C16 and feed the wire through the top of the battery current
transducer (x).
(9)
Remove the bolts (9), washer (10) and nuts (11) on the battery current transducer.
(10) Place new battery current transducer on bracket (12). Verify that holes line up with mounting
bracket (12).
(11) Attach battery current transducer (1) to bracket (12) with bolts (9), washer (10) and nuts (11).
(12) Feed wire number 310A16 through the battery current transducer.
(13) Strip 1/4 " of insulation from the end of wire 310A16.
(14) Crimp ring terminal (8) to the end of wire 310A16.
(15) Attach wire number 310A16 to the positive post of the alternator with isolating washer (7), terminal
washer (6), washer (5) and nut (4).
(16) Feed wire number 145C16 through the top of the battery current transducer (1) and route to the
battery compartment.
(17) Strip 1/4 " of insulation from the end of wire 145C16.
(18) Crimp ring terminal to the end of wire 145C6.
(19) Attach wire number 145C16 to the positive post of battery number one. Refer to Schematic FO-1.
(20) Reconnect negative cable to battery.
(21) Close battery access door, (Figure 1-2).
(22) Close right side engine compartment access door, (Figure 1-2).
