ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-141
(7)
Remove bolts (32, Figure 4-18), lockwashers (33), washers (34), and mounting bracket (35) from
DCS control box bottom (42).
(8)
Remove locknuts (36), screws (37), and relay track (38) from DCS control box bottom (42).
(9)
Remove locknuts (39), screws (40), and latch plate (41) from DCS control box bottom (42).
(10) Remove screws (30, Figure 4-15), lockwashers (31), washers (32), and standoffs (21 and 26) from
DCS control box bottom (42, Figure 4-18).
b. Inspection.
(1)
Inspect DCS control panel bottom (42, Figure 4-18) for dents, cracks, loose paint, and corrosion.
(2)
Inspect for missing or damaged cage nuts (43).
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
(4)
Replace missing or damaged cage nuts (43).
d. Installation.
(1)
Install standoffs (21 and 26, Figure 4-15), washers (32), lockwashers (31), and screws (30) on DCS
control box bottom (42, Figure 4-18).
(2)
Install latch plate (41), screws (40), and locknuts (39) on DCS control box bottom (42).
(3)
Install relay track (38), screws (37), and locknuts (36) on DCS control box bottom (42).
(4)
Install mounting bracket (35), washers (34), lockwashers (33), and bolts (32) on control box bottom
(42).
(5)
Install DCS control box side panels, paragraph 4.8.41.
(6)
Install DCS control panel frame, paragraph 4.8.40.
(7)
Install control box components, paragraphs 4.8.21 through 4.8.36.
(8)
Install DCS control box assembly, paragraph 4.8.1.
(9)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
