ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-139
(2)
Apply continuous bead, approximately .12 inch in diameter, of sealant (Item 18, Appendix E) to
mating surfaces of DCS control panel frame (14), DCS control box bottom (42), and side panels (26
and 27). Immediately install DCS control panel frame (14), bolts (13 and 11), and locknuts (12 and
10) on DCS control box assembly (Figure 4-10).
(3)
Install CONVENIENCE RECEPTACLE, paragraph 4.8.20.
(4)
Install PARALLELING RECEPTACLE, paragraph 4.8.19.
(5)
Install COMMUNICATION RECEPTACLE, paragraph 4.8.18.
(6)
Install DCS control panel assembly, paragraph 4.8.39.
(7)
Install keypad assembly, paragraph 4.8.17.
(8)
Install CIM, paragraph 4.8.16.
(9)
Install DCS control box assembly, paragraph 4.8.1.
(10) Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.41 DCS Control Box Side Panels.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Remove locknuts (12, Figure 4-18) and bolts (13) securing side panels (26 and 27) to DCS control
panel frame (14).
(5)
Open output box access door (Figure 1-2), and remove locknuts (19) and bolts (20) securing side
panel (27) to generator set.
(6)
Remove bolts (21), lockwashers (22), and washers (23) securing side panels (26 and 27) to
generator set.
(7)
Remove locknuts (24), bolts (25), and side panels (26 and 27) from DCS control box assembly.
(8)
Remove locknuts (28), bolts (29), and air baffle (30) from side panel (27).
b. Inspection.
(1)
Inspect DCS control panel frame (14, Figure 4-18) for dents, cracks, loose paint, and corrosion.
(2)
Inspect for missing or damaged cage nuts (31).
