ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-138
4.8.40 DCS Control Panel Frame.
a. Inspection.
Inspect DCS control panel frame (14, Figure 4-18) for dents, cracks, loose paint, and corrosion.
b. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box assembly, paragraph 4.8.1.
(4)
Remove CIM, paragraph 4.8.16
(5)
Remove keypad assembly, paragraph 4.8.17.
(6)
Remove DCS control panel assembly, paragraph 4.8.39.
(7)
Remove COMMUNICATION RECEPTACLE, paragraph 4.8.18. Do not disconnect electrical
leads from COMMUNICATION RECEPTACLE.
(8)
Remove PARALLELING RECEPTACLE, paragraph 4.8.19. Do not disconnect electrical leads
from PARALLELING RECEPTACLE.
(9)
Remove CONVENIENCE RECEPTACLE, paragraph 4.8.20.
(10) Remove locknuts (10 and 12, Figure 4-18), bolts (11 and 13), and DCS control panel frame (14)
from DCS control box assembly (Figure 4-10).
(11) If necessary, drill out rivets (15 and 17, Figure 4-18), and remove data plates (16 and 18).
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
d. Installation.
(1)
If removed, install data plates (16 and 18, Figure 4-18) on DCS control panel (14) with rivets (15
and 17).
