ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-67
(21) Remove panel clips (65) and insulation (66 and 67) from floor panel (35).
b. Inspection.
(1)
Remove top housing section, step a above.
(2)
Inspect all top housing section panels for dents, cracks, loose paint, and corrosion.
(3)
Inspect cage nuts (68 through 75, Figure 4-7) for cracking or stripped threads.
(4)
Inspect insulation (51 through 61, 63, 64, 66 and 67) for damage and missing clip halves (50, 62, 76
and 78), push-on nuts (77 and 79), and panel clips (65) as applicable.
(5)
Inspect seal (80) and door seals (81 and 82) for tears, looseness, and deterioration.
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
(4)
Replace cage nuts (68 through 75, Figure 4-7) that are stripped or cracked.
(5)
Replace damaged insulation (51 through 61, 63, 64, 66 and 67).
(6)
Replace missing or damaged clip halves (50, 62, 76 and 78), push-on nuts (77 and 79), and panel
clips (65).
(7)
Replace damaged seal (80) or door seals (81 and 82). Refer to Appendix E.
d. Installation.
(1)
Install insulation (66 and 67, Figure 4-7) on floor panel (35) with panel clips (65).
(2)
Install insulation (63 and 64) on side panels (33 and 34) with clip halves (62).
(3)
Install insulation (51 through 61) on top panel (12) with clip halves (50).
(4)
Install angle (49) on generator set with bolts (48) and locknuts (47). Close output box access door.
(5)
Install bracket (46), bolt (45), and locknut (44) on angle (49).
(6)
Install side panels (33 and 34), bolts (43), and locknuts (42) on floor panel (35).
