ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-62
b. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Inspect top panel (4, Figure 4-6) for dents, cracks, loose paint, corrosion, and missing mounting
hardware.
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
d. Installation.
(1)
Apply tear drop gasket (Item 18, Appendix E) to mating surface of door ring retainer (14, Figure 4-
6). Position door ring (15) and door ring retainer on top panel (4), and install bolts (13) and
locknuts (12).
(2)
Install stiffener (11), bolts (10), washers (9), lockwashers (8), and nuts (7) on DCS control box
assembly.
(3)
Install top panel (4) on control box with bolts (6) and locknuts (5).
(4)
Install washers (3), lockwashers (2), and bolts (1) on top panel (4).
(5)
Raise and secure DCS control panel with two fasteners.
(6)
Install DCS control box door. Refer to paragraph 4.7.1.
(7)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.7.3 Top Housing Section.
a. Removal.
(1)
Shut down generator set, paragraph 2.12.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
__________
