ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-59
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
NOTE
Step (4) applies to all access doors except the load terminal access
door .
NOTE
Sealant is applied to all four corners of the output box access
door.
(4)
Apply industrial sealant (Item 18, Appendix E) to top two corners of access door.
(5)
Replace damaged or unreadable data plates.
(6)
Replace loose or missing rivets.
d. Installation.
(1)
Position latches (32, Figure 4-5) on door (6) as noted during removal. Secure latches to door with
screws (31), and locknuts (30).
(2)
Install bracket (29), bolts (28), and locknuts (27) on door (6).
(3)
Install bracket (25), holding rod (26), bolts (24), and locknuts (23) on door (6).
(4)
Install wiring diagram data plate (20) on air baffle (13) with rivets (19).
(5)
Install air baffle (13), bolts (12), and locknuts (11) on door (6).
(6)
Install hinges (5), bolts (10), washers (9), lockwashers (8), and nuts (7) on door (6).
(7)
Position door (6) on generator set housing, and install hinges (5), bolts (4), washers (3), lockwashers
(2), and nuts (1).
(8)
Close engine compartment access doors.
