ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-71
(17) Remove locknuts (45), bolts (46), and support (47) from panel (44).
(18) Remove locknuts (48), bolts (49), and support channel (50) from front housing (14).
(19) Remove locknuts (51), bolts (52), and SLAVE RECEPTACLE box (53) from front housing (14).
(20) Remove locknuts (54), bolts (55), and brackets (56) from door sill (22) and front housing (14).
b. Inspection.
(1)
Shut down generator set, paragraph 2.12.2.
(2)
Inspect all front housing section panels for dents, cracks, loose paint, corrosion, and other damage.
(3)
Inspect cage nuts (57 through 62, Figure 4-8) for cracking or stripped threads.
(4)
Inspect insulation (25) for damage and missing clip halves (24 and 63) and push-on nuts (64).
(5)
Inspect seals (65 through 67) for tears, looseness and deterioration.
(6)
Inspect identification plates (68, 70 and 72) for readability and loose or missing rivets (69, 71 and
73).
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1) Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
(4)
Replace stripped or cracked cage nuts (57 through 62, Figure 4-8).
(5)
Replace damaged insulation (25) and missing or damaged clip halves (24 and 63) or push-on nuts
(64).
(6)
Replace damaged seals (65 through 67). Refer to Table E.
(7)
Replace damaged or unreadable identification plates (68, 70 and 72).
(8)
Replace loose or missing rivets (69, 71 and 73).
d. Installation.
(1)
Install brackets (56, Figure 4-8), bolts (55), and locknuts (54) on front housing (14) and door sill
(22).
