ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-73
(4)
Remove output box access door, load terminal board access door, rear engine compartment access
doors, and air cleaner access doors. Refer to paragraph 4.7.1.
(5)
Remove fuel tank filler neck, paragraph 4.11.3.
(6)
Remove auxiliary fuel pump, paragraph 4.11.2.
(7)
Remove ether solenoid valve, paragraph 4.11.8.
(8)
Remove top housing panel. Refer to paragraph 4.7.3.
(9) Remove output box. Refer to paragraph 5.8.
(10) Remove nuts (1, Figure 4-9), lockwashers (2), washers (3), and bolts (4) from rear panel (8) and
skid base.
(11) Remove bolts (5), lockwashers (6), washers (7), and rear panel (8) from corner post (54) and left
side rear panel (25).
(12) Remove locknuts (11), bolts (12), and load terminal access box (13) from rear panel (8).
(13) Remove clip halves (76) and insulation (10) from rear panel (8).
(14) Remove nuts (14), lockwashers (15), washers (16), and bolts (17) from left side rear panel (25) and
engine compartment door seal (90).
(15) Remove nut (18), lockwasher (19), washer (20), and bolt (21) from left side rear panel (25).
(16) Remove bolts (22), lockwashers (23), washers (24), and left side rear panel (25) from skid base.
(17) Remove locknuts (26), bolts (27), and air baffle (28) from left side rear panel (25).
(18) Remove clip halves (29) and insulation (30) from air baffle (28).
(19) Remove locknuts (31), bolts (32), and support bracket (33) from left side rear panel (25).
(20) Remove locknuts (34), bolts (35), and filler neck panel (36) from left side rear panel (25).
(21) Remove locknuts (37), bolts (38), and document box top (39) from left side rear panel (25).
(22) Remove clip halves (40) and insulation (41) from left side rear panel (25).
(22) Remove locknuts (44), bolts (45), and output box sill (46) from corner post (54) and panel (64).
(23) Remove locknuts (47) and bolts (48) from door sill (53), corner post (54) and panel (64).
(24) Remove nuts (49), lockwashers (50), washers (51), bolts (52), door sill (53), and corner post (54)
from skid base. Scrape sealant from mating surfaces of corner post and output box top.
(25) Remove nuts (57), lockwashers (58), and washers (59), and bolts (60) from panel (64).
(26) Remove bolts (61), lockwashers (62), washers (63), and panel (64) from skid base. Scrape sealant
from mating surfaces of panel and output box top.
