ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-135
c. Repair.
(1)
As necessary, remove components from DCS control panel assembly (6), paragraphs 4.8.2 through
4.8.15.
_________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(2)
Repair all dents and cracks, and remove loose paint.
(3)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(4)
Repaint surfaces in accordance with TM 43-0139.
(5)
Install components removed in step (1), paragraphs 4.8.2 through 4.8.15.
d. Installation.
(1)
Install hinge (9, Figure 4-18), bolts (8), and locknuts (7) on DCS control panel frame (14).
(2)
Install DCS control panel assembly (6), bolts (5), and locknuts (4) on hinge (9).
(3)
Install hook on panel holder (3) in hole in DCS control panel frame (14). Install panel holder (3),
screw (2), and locknut (1) on DCS control panel assembly (6).
(4)
Install components, paragraphs 4.8.2 through 4.8.15.
(5)
Raise and secure DCS control panel.
(6)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.40 DCS Control Panel Frame.
a. Inspection.
Inspect DCS control panel frame (14, Figure 4-18) for dents, cracks, loose paint, and corrosion.
b. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box assembly, paragraph 4.8.1.
(4)
Remove CIM, paragraph 4.8.16.
(5)
Remove keypad assembly, paragraph 4.8.17.
(6)
Remove DCS control panel assembly, paragraph 4.8.39.
