ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-130
(8)
Install resistors (36 and 35, Figure 4-16), screws (34), lockwashers (33), and nuts (32) on air baffle
(30, Figure 4-18) of DCS control box assembly.
(9)
Solder electrical leads to resistors (36 and 35, Figure 4-16). Remove tags.
(10) Install air baffle, refer to paragraph 4.8.41.
(11) Install CIM, refer to paragraph 4.8.16.
(12) Install DCS control box top panel, paragraph 4.7.2.
(13) Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.36 Resistor R6.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Inspect resistor (41, Figure 4-16) for cracks, breaks, corrosion, bent terminals, and other damage.
(4)
Install DCS control box top panel, paragraph 4.7.2.
b. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Set multimeter for ohms, and measure resistance across resistor (41, Figure 4-16). Multimeter
indication should be 40 ohms.
(5)
If any indications are other than above, replace resistor.
(6)
Install DCS control box top panel, paragraph 4.7.2.
(7)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
