ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-126
a. Inspection.
Inspect auxiliary control bracket (18, Figure 4-16) for dents, cracks, loose paint, and corrosion.
b. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Remove auxiliary control bracket components, paragraphs 4.8.26 through 4.8.31.
(5)
Remove bolts (17, Figure 4-16) and auxiliary control bracket (18) from floor of DCS control box
assembly.
(6)
Remove screws (19) and terminals (20) from auxiliary control bracket (18).
c. Repair.
(1)
As necessary, remove components from auxiliary control bracket (18, Figure 4-16), paragraphs
4.8.26 through 4.8.31.
_________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(2)
Repair all dents and cracks, and remove loose paint.
(3)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(4)
Repaint surfaces in accordance with TM 43-0139.
(5)
Install components removed in step (1), paragraphs 4.8.26 through 4.8.31.
d. Installation.
(1)
Install terminals (20, Figure 4-16) and screws (19) on auxiliary control bracket (18).
(2)
Install auxiliary control bracket (18) and bolts (17) on floor of DCS control box assembly.
(3)
Install auxiliary control bracket components, paragraphs 4.8.26 through 4.8.31.
(4)
Install DCS control box top panel, paragraph 4.7.2.
(5)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.33 VOLTAGE SELECTION Switch S20.
a. Inspection.
