ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-129
(2)
Install DCS control box top panel, paragraph 4.7.2.
(3)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.35 Resistors R16 and R17.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Inspect resistors (35 and 36, Figure 4-16) for cracks, loose mounting, and other damage.
(4)
Install DCS control box top panel, paragraph 4.7.2.
b. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Set multimeter for ohms, and measure resistance across resistor R16 (35). Multimeter indication
should be 50 ohms.
(5)
Set multimeter for ohms, and measure resistance across resistor R17 (36). Multimeter indication
should be 50 ohms.
(6)
If indications are other than above, one or both resistors is defective and must be replaced.
(7)
Install DCS control box top panel, paragraph 4.7.2.
(8)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
c. Replacement.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Remove CIM control box assembly, paragraph 4.8.16.
(5)
Remove air baffle. Refer to paragraph 4.8.41.
(6)
Tag and desolder electrical leads from resistors (35 and 36, Figure 4-16).
(7)
Remove nuts (32), lockwashers (33), screws (34) and resistors (35 and 36) from air baffle (30,
Figure 4-18) of DCS control box assembly.
