ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-139
(3)
Secure side panels (27 and 26) to generator set with washers (23), lockwashers (22), and bolts (21).
(4)
Secure side panel (27) to generator set with bolts (20) and locknuts (19). Close output box access
door (Figure 1-2).
(5)
Apply continuous bead, approximately .12 inch in diameter, of sealant (Item 18, Appendix E) to
mating surfaces of side panels (27 and 26, Figure 4-18). Immediately secure side panels (26 and 27)
to DCS control panel frame (14) with bolts (13) and locknuts (12).
(6)
Install DCS control box top panel, paragraph 4.7.2.
(7)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.46 DCS Control Box Bottom.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box assembly, paragraph 4.8.1.
(4)
Remove control box components, paragraphs 4.8.21 through 4.8.36.
(5)
Remove DCS control panel frame, paragraph 4.8.40.
(6)
Remove DCS control box side panels, paragraph 4.8.41.
(7)
Remove bolts (32, Figure 4-18), lockwashers (33), washers (34), and mounting bracket (35) from
DCS control box bottom (42).
(8)
Remove locknuts (36), screws (37), and relay track (38) from DCS control box bottom (42).
(9)
Remove locknuts (39), screws (40), and latch plate (41) from DCS control box bottom (42).
(10) Remove screws (30, Figure 4-15), lockwashers (31), washers (32), and standoffs (21 and 26) from
DCS control box bottom (42, Figure 4-18).
b. Inspection.
(1)
Inspect DCS control panel bottom (42, Figure 4-18) for dents, cracks, loose paint, and corrosion.
(2)
Inspect for missing or damaged cage nuts (43).
