ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-136
(7)
Remove COMMUNICATION RECEPTACLE, paragraph 4.8.18. Do not disconnect electrical
leads from COMMUNICATION RECEPTACLE.
(8)
Remove PARALLELING RECEPTACLE, paragraph 4.8.19. Do not disconnect electrical leads
from PARALLELING RECEPTACLE.
(9)
Remove CONVENIENCE RECEPTACLE, paragraph 4.8.20.
(10) Remove locknuts (10 and 12, Figure 4-18), bolts (11 and 13), and DCS control panel frame (14)
from DCS control box assembly (Figure 4-10).
(11) If necessary, drill out rivets (15 and 17, Figure 4-18), and remove data plates (16 and 18).
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
d. Installation.
(1)
If removed, install data plates (16 and 18, Figure 4-18) on DCS control panel (14) with rivets (15
and 17).
(2)
Apply continuous bead, approximately .12 inch in diameter, of sealant (Item 18, Appendix E) to
mating surfaces of DCS control panel frame (14), DCS control box bottom (42), and side panels (26
and 27). Immediately install DCS control panel frame (14), bolts (13 and 11), and locknuts (12 and
10) on DCS control box assembly (Figure 4-10).
(3)
Install CONVENIENCE RECEPTACLE, paragraph 4.8.20.
(4)
Install PARALLELING RECEPTACLE, paragraph 4.8.19.
(5)
Install COMMUNICATION RECEPTACLE, paragraph 4.8.18.
(6)
Install DCS control panel assembly, paragraph 4.8.39.
(7)
Install keypad assembly, paragraph 4.8.17.
(8)
Install CIM, paragraph 4.8.16.
(9)
Install DCS control box assembly, paragraph 4.8.1.
(10) Connect negative battery cable to battery, and close BATTERY ACCESS door.
