TM 9-6115-670-14&P 5-100 d.  Remove two nuts and flat washers (2, Figure 4-6), two rubber washers (3), two lock washers and bolts (4) securing radiator (1) to radiator mount (5). e.  Remove one bolt, flat washer and lock washer (8, Figure 4-42) and ground strap (7) from frame. f.   Remove four bolts, flat and lock washers (9, Figure 4-19) (JTACS and WIN-T), or four bolts and flat washers (5, Figure 4-20) (SICPS) securing fuel day tank assembly to frame. g.  (JTACS and WIN-T) remove one bolt, flat and lock washer (31, Figure 5-24) and hex nut (33) securing fuel hose clamp (32) to isolator mount. h.  Remove one screw, flat and lock washer (3, Figure 4-18) (SICPS) securing fuel pump bracket (1) to generator mount (8), or one bolt, flat and lock washer, and spacer (JTACS and WIN-T) securing fuel pump bracket (1) to isolator mount. i.   Remove four hex-head socket screws (20, Figure 5-24) and spacers (19) securing alternator to isolator mount (JTACS and WIN-T only). j.   Secure lifting device to lifting eyes (5 and 6). k.  (SICPS) remove four bolts, flat and lock washers (5) securing APU (9) to resilient mounts (6). l.     (JTACS and WIN-T) remove two bolts, flat washers (26) and lock nuts (29) securing APU to     vibration isolator mount (28) NOTE Do  not  remove  fuel  pump  assembly  from  fuel  pump bracket.      Place   hardware   back   on   bracket   after removing bracket from frame/mount. NOTES The four spacers are located between frame and alternator.    They  are  not  accessible  until  unit  is removed from frame. Ensure  24  VDC  to  starter  is  disconnected  (para 4.37.)   and   AC   output   is   disconnected   before removing APU from frame assembly. CAUTION Prior to removing the bolts that secure the unit to the frame,  ensure  the  lifting  device  is  attached  to  lifting eyes  in  order  to  prevent  damage  to  equipment  or serious injury to personnel.