TM 9-6115-670-14&P
5-102
v. (JTACS and WIN-T) Install fuel hose clamp (32, Figure 5-24) to isolator mount with one bolt,
flat and lock washer (31) and hex nut (33).
w. Install fuel day tank assembly to frame with four bolts, flat and lock washers (9, Figure 4-19)
(JTACS and WIN-T), or four bolts and flat washers (5, Figure 4-20) (SICPS).
x. Install ground strap (7, Figure 4-42) to frame with one bolt, flat washer and lock washer (8).
y. Install radiator (1, Figure 4-6) on radiator mount (5), and secure with two bolts, lock washers,
rubber washers, flat washers, and nuts.
z. Install radiator support bracket to frame and radiator with two screws, flat and lock washers (15,
Figure 4-5), two screws (JTACS), or two slotted hex-head screws (SICPS and WIN-T), flat and
lock washers (17).
aa. Install air intake pipe to turbo charger with two nuts and lock washers (1, Figure 4-35) (JTACS),
or two bolts (SICPS and WIN-T).
ab. Service radiator with coolant (para 4.19.).
REPAIR
a. To repair SICPS (MODEL MEP-903A) frame assembly (10), proceed as follows:
(1) Remove eight screws, lock washers, and washers (12) and remove two engine vibration
mounts (11).
(2) Remove eight screws, lock washers, and washers (13) and remove two generator
vibration mounts (14).
(3) Remove eighteen screws (16) and remove two runners (15).
(4) Install two runners (15) and secure with eighteen screws (16).
(5) Install two generator vibration mounts (14) and secure with eight screws, lock washers,
and washers (13).
(6) Install two engine vibration mounts (11) and secure with eight screws, lock washers, and
washers (12).
b. To repair JTACS (MODEL MEP-903B) or WIN-T (MODEL MEP-903C) APU frame assembly
(17), refer to Figure 5-24 (sheet 4 and 5) and proceed as follows:
(1) Remove ten hex-head bolts (30), flat and lock washers securing isolator mount assembly
(18) to frame.
(2) Remove four screws, washers, and lock washers (21) and remove two pull handle
brackets (22 and 24) and pull handle (23).
NOTE
If repairing JTACS (MODEL MEP-903B) or WIN-T
(MODEL MEP-903C) frame assembly, proceed to step
b.
