TM 9-6115-647-14&P
(2)
Slide EMI gasket (13) over J4 harness wires (9) and up against J4 connector flange. Feed J4
harness wires through J4 connector opening In adapter plate (6) and mount connector and
gasket to adapter plate with four screws (10), four flat washers (11) and four self-locking nuts
(12). Reconnect J4 harness wires to terminal board TB2 (2). (See figure 5-3 for wire routing
Information).
(3)
Slide EMI gasket (7) over J3 harness wires (1) and up against J3 connector flange. Feed J3
harness wires through J3 connector opening in adapter plate (6). Secure surge protectors
(5.5) to the adapter plate (6) using three bolts (5.1), three flat washers (5.2), three lockwashers
(5.3) and three nuts (5.4). Mount connector and gasket to adapter plate (6) with four screws
(3), four flat washers (4) and four self-locking nuts. (5). Make sure tab of connector cover
chain (18) is mounted to connector with lower right corner hardware. Reconnect J3 harness
wires to generator set load terminals and terminal board TB2 (2) (See figure 5-3 for wire
routing information.
(4)
Reconnect P3 power/control cable and P4, P7 fuel cable Reconnect ground cable to adapter
plate GROUND.
(5)
Close generator set side panel.
Figure 5-3. Adapter Plate Assembly Wiring Diagram.
Change 1
5-7
