TM 9-6115-647-14&P
(d)
If hinge (23) was removed, position hinge on edge of cover (2) and fasten with eight
rivets (24). Install rivets with heads on Inside.
(e)
Position cover (2) on housing (7) and fasten with eight screws (12), eight flat washers
(13) and eight self-locking nuts (14).
(f)
On alternate screws (12), inside housing (7), replace four clamps (11). Dress wires into
clamps.
(g)
Close PDU cover (2) and secure with latch (1).
e.
PDU Housing Repair. In addition to latch replacement described below, the PDU housing may be
straightened, welded and repainted. If required, repaint in accordance with MIL-T-704, Type G, Color Green,
No. 383 of MIL-C-46168. If power unit is painted in camouflage, refer to Section VI, Power Unit Marking.
Replace latch as follows:
(1)
Removal.
(a)
Release latch (1, figure 5-5) and open PDU cover (2).
(b)
Drill out two rivets (30) and remove latch (1) from PDU housing (7) Be careful not to
enlarge rivet holes when removing rivets.
(2)
Installation.
(a)
Position latch (1) on housing (7) and fasten with two rivets (30). Install rivets with heads
on outside of housing.
(b)
Close cover (2) and secure with latch (1).
5-12
