TM 9-6115-647-14&P
Figure 5-2. Adapter Plate Assembly Repair.
b.
Wiring Harness Repair. If required, J3 and J4 wiring harnesses may be repaired by replacing
broken wires, terminals or connector pins. Refer to paragraph 5-5 for wing harness repair procedures
c.
Reassembly.
(1)
If jumper (17) was removed during disassembly, unscrew one terminal screw (16) on terminal
1 and adjacent screw (16) on terminal 2, position jumper over screw holes and reinstall
screws. Position terminal board TB2 (2) and marker strip (15) on welded bracket inside
adapter place (6) and fasten with two screws (14). Reconnect wires. (See figure 5-3 for wire
routing information.)
5-6
Change 1
