ARMY TM 9-6115-45-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
2–1 8.2
a.
b.
c.
d.
e.
f.
2–1 8.3
a.
b.
c.
d.
e.
f.
g.
2–1 8.4
a.
b.
c.
d.
e.
f.
g.
h.
i .
Inspection.
Shut down generator set.
Inspect rear housing section panels for dents, cracks, loose paint, corrosion, and other damage.
Inspect all cage nuts (72, FIGURE 2-9) for cracking or stripped threads.
Inspect all insulation for damage and missing clip halves.
Inspect EMI seals (73) for tears, looseness, and deterioration.
Inspect door seals (74) for tears, looseness, and deterioration.
Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surfaces in accordance with TM 43-0139. (F) Use applicable directives.
Replace all cracked or stripped cage nuts (72, FIGURE 2-9).
Replace damaged insulation and missing clip halves. Refer to Appendix D for fabrication of insulation.
Replace EMI seals (73) that are loose or show any evidence of damage.
Replace damaged door seals (74).
Installation.
If removed, install plate (71, FIGURE 2-9) on fuel filler neck panel (30) with rivets (70).
If removed, install plate (69) on side panel (19) with rivets (68).
If removed, install insulation (65) on panel (58) with clip halves (64).
If removed, install insulation (63) on baffle (61) with clip halves (62).
Install baffle (61) on panel (58) with bolts (59) and assembled nuts (60).
Install right side panel (58) on generator set with bolts (47), (50), (54), and (56); flatwashers (49) and (51); Iock-
washers (48) and (52); nuts (53); and assembled nuts (55) and (57).
Install door sills (45) and (46), and corner post (44) on generator set with bolts (36), (40) and (42); flatwashers
(37); Iockwashers (38); nuts (39); and assembled nuts (41) and (43).
If removed, install insulation (35) on panel (19) with clip halves (34).
Install document box (33) on left side rear panel (19) with bolts (31) and assembled nuts (32).
2-45
