ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARlNE CORPS TM 09244A/09245A-24/2
2-17.3
a.
b.
c.
d.
e.
f.
2–17.4
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
p.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surfaces in accordance with TM 43-0139. (F) Refer to applicable directives.
Replace any cracked or stripped cage nuts (61, FIGURE 2-8).
Replace damaged insulation and missing clip halves. Refer to Appendix D for fabrication of insulation.
Replace loose or damaged seals (62) and (63).
Installation.
If removed, install identification plates (58, 59, and 60, FIGURE 2-8) on front panel (14) with pop rivets (55),
(56), and (57).
Install brackets (54) on panels (14) and (22) with bolts (52) and assembled nuts (53).
Install slave receptacle box (51 ) on front housing panel (14) with bolts (49) and assembled nuts (50).
Install side panels (22) and (23) on generator set with bolts (15) and (1 8), flatwashers (17) and (1 9), lockwash-
ers (16) and (20), and nuts (21).
Install support channel (48) on front panel (14) with bolts (46) and assembled nuts (47).
Install support (45) on panel (42) with bolts (43) and assembled nuts (44).
Install panel (42) on front panel (14) with bolts (41).
Install supports (39) and (40) on panels (35) and (36) with bolts (37) and assembled nuts (38).
Install panels (35) and (36) on front panel (14) with bolts (32), lockwashers (33), and washers (34).
Install air deflector (31 ) on front panel (14) with bolts (26) and (29), washers (28), lockwashers (27), and as-
sembled nuts (30).
Install insulation (25) on front panel (14) with clip halves (24).
Install front housing panel (14) on generator set with bolts (3), (6), and (1 O); flatwashers (5), (7), and (11); lock-
washers (4) (8), and (12); and nuts (9) and (13).
Install slave receptacle, paragraph 2-13.3 and batteries, paragraph 2-12.5.
Install battery box access door and engine access doors, paragraph 2–1 4.4.
Install top housing section, paragraph 2-16.4.
Install ground rods (2) in brackets (54) and secure with bolts (1). Close all access doors.
2-42
