ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
2-18 REAR HOUSING SECTION.
2-18.1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
p.
q.
r.
s.
t.
u.
v.
w.
x.
y.
z.
aa.
ab.
Removal.
Shut down generator set.
Remove control box assembly, paragraph 2-19.2.
Remove air cleaner assembly, paragraph 2-73.2.
Remove output box access door and load terminal board access door, paragraph 2–1 4.1.
Remove rear engine access doors, document box access door, and aircleaner access door, paragraph 2–14.1.
Remove fuel filler neck, paragraph 2-87.1.
Remove auxiliary fuel pump, paragraph 2-86.3.
Remove fuel float module, paragraph 2-92.3.
Remove ether solenoid valve, paragraph 2-94.1.
Remove top housing panel, paragraph 2-16.1, step d.
Remove bolts (1 and 4, FIGURE 2-9), flatwashers (3) and (5), Iockwashers (2) and (6), nuts (7), and rear panel
(8) from generator set.
Remove bolts (9), assembled nuts (10), and load cable entrance box(11) from panel (8).
Remove bolts (12) and (16), flatwashers(13) and (18), lockwashers(14) and (17), nuts (15), and left side rear
panel (19) from generator set.
Remove bolts (20), assembled nuts (21), and baffle (22) from panel (19).
Remove clip halves (23) and insulation (24) from baffle (22).
Remove bolts (25), assembled nuts (26), and stiffener (27) from baffle (22).
Remove bolts (28), assembled nuts (29), and fuel filler neck panel (30) from panel (19).
Remove bolts (31), assembled nuts (32), and document box (33) from panel (19).
If necessary, remove clip halves (34) and insulation (35) from panel (19).
NOTE
Ensure output box assembly is secured prior to removal of corner post and door sills.
Remove bolts (36), (40), and (42); flatwashers (37); Iockwashers (38); nuts (39); assembled nuts (41) and (43);
corner post (44); and door sills (45) and (46) from generator set.
Remove bolts (47), (50), (54), and (56); flatwashers (49) and (51); Iockwashers (48) and (52); nuts (53); as-
sembled nuts (55) and (57); and right side panel (58) from generator set.
Remove bolts (59), assembled nuts (60), and baffle (61) from panel (58).
If necessary, remove clip halves (62) and insulation (63) from baffle (61).
If necessary, remove clip halves (64) and insulation (65) from panel (58).
If necessary, remove clip halves (66) and insulation (67) from panel (8).
If necessary, drill out rivets (68) and remove plate (69) from side panel (19).
If necessary, drill out rivets (70) and remove plate (71) from fuel filler neck panel (30).
If necessary, remove output box EMI seals (73) from door sill (45), corner post (44), and right side panel (58).
2-43
