ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
2-16.3
a.
b.
c.
d.
e.
f.
2-16.4
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
p.
q.
Repair.
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surfaces in accordance with TM 43-0139. (F) Refer to applicable directives.
Replace any cage nuts (72, FIGURE 2-7) that are stripped or cracked.
Replace damaged sound insulation and missing clip halves. Refer to Appendix D for fabrication of insulation.
Replace loose or damaged seal (73).
Installation.
Install angle (53, FIGURE 2-7) in generator set with bolts (51) and assembled nuts (52).
Install bracket (50) to angle (53) with bolt (48) and assembled nut (49).
Install insulation (55) through (65) on top panel (6) with clip halves (54) as required.
Install insulation (67) and (68) on side panels (37) and (38) with clip halves (66) as required.
Install insulation (70) and (71) on top floor panel (39) with clip halves (69) as required.
Install top side panels (37) and (38) on top section floor panel (39) with bolts (46) and assembled nuts (47).
Install support (45) on panel (42) with bolts (43) and assembled nuts (44).
Install panel (42) on top section floor panel (39) with bolts (40) and assembled nuts (41).
Position top section floor panel (39), with side and front paneIs attached, in generator set and secure with bolts
(28), (30), and (34); flatwashers (31) and (36); Iockwashers (32) and (35); assembled nuts (29); and nuts (33).
Install panel (27) with bolts (23) and (25), and assembled nuts (24) and (26).
Install air duct channels (21) and (22) with bolts (18), Iockwashers (19), and washers (20).
Install muffler, paragraph 2-71.3.
Install frame (17) with bolts (14), flatwashers (16), and Iockwashers (15).
Install radiator fill panel (13) in generator set and connect radiator fill hose and overflow hose to panel (13).
Install top housing panel (6) with bolts (7) and (10), flatwashers (9) and (12), and Iockwashers (8) and (11).
Install mount (4) and exhaust cover (5) with bolts (1), flatwashers (3), and Iockwashers (2).
Install control box assembly, paragraph 2-19.4.
2-39
