ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
2-16 TOP HOUSING SECTION.
2-16.1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
p.
q.
r.
2-16.2
a.
b.
c.
d.
e.
Removal.
Shut down generator set,
Remove control box assembly, paragraph 2-19.2.
Top housing panels can get very hot. Allow panels to cool down before perform-
ing maintenance. Failure to observe this warning could result in severe burns.
Remove bolts (1, FIGURE 2-7), flatwashers (3), Iockwashers (2), mount (4), and exhaust cover (5) from top
housing panel (6).
Remove bolts (7) and (10), flat-washers (9) and (12), Iockwashers (8) and (11), and top housing panel (6) from
generator set.
Disconnect radiator fill hose and overflow hose from radiator fill panel (13) and remove radiator fill panel (13)
from generator set.
Remove bolts (14), flatwashers (16), Iockwashers (15), and frame (17) from generator set.
Remove muffler, paragraph 2-71.2.
Remove bolts (18), Iockwashers (19), washers (20), and air duct channels (21) and (22).
Remove bolts (23) and (25), assembled nuts (24) and (26), and panel (27).
Remove bolts (28), (30) and (34), flatwashers (31) and (36), Iockwashers (32) and (35), assembled nuts (29),
nuts (33), and top side panels (37) and (38) with top section floor panel (39).
Remove bolts (40), assembled nuts (41), and panel (42) from floor panel (39).
Remove bolts (43), assembled nuts (44), and support (45) from panel (42).
Remove bolts (46), assembled nuts (47), and side panels (37) and (38) from floor panel (39).
Remove bolt (48), assembled nut (49), and bracket (50) from angle (53).
Remove bolts (51), assembled nuts (52), and angle (53) from generator set. Open output box access door to
reach assembled nuts (52).
Remove clip halves (54) and insulation (55) through (65) from top panel (6) as necessary.
Remove clip halves (66) and insulation (67) and (68) from side panels (37) and (38) as necessary.
Remove clip halves (69) and insulation (70) and (71) from top floor panel (39) as necessary.
Inspection.
Shut down generator set.
Inspect all top housing section panels for dents, cracks, loose paint, and corrosion.
Inspect all cage nuts (72, FIGURE 2-7) for cracking or stripped threads.
Inspect sound insulation for damage and missing clip halves.
Inspect seal (73) for tears, looseness, and deterioration.
2-36
