ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
SECTION IX. MAINTENANCE OF HOUSING
2-14 ACCESS DOORS.
2-14.1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
1.
2-14.2
a.
b.
c.
d.
2-14.3
a.
b.
c.
d.
e.
f.
g.
NOTE
This procedure is written for the right rear engine access door, but is typical for all access
doors, hinges, latches, and data plates.
NOTE
When removing and installing battery access door, note position of spacers for door hold
open mechanism.
Removal.
Shut down generator set.
Open right side engine access doors.
Remove nuts (1, FIGURE 2-5), Iockwashers (2), bolts (3), washers (4), and hinges (5).
Remove right rear engine access door (6) from generator set.
Remove assembled nuts (7), bolts (8), and air baffle (9) from engine access door (6).
Remove clip halves (10) and insulation (11) from air baffle (9).
Remove bolts (12), Iockwashers (13), washers (14), and bracket (15) from air baffle (9).
Drill out pop rivets (16) and remove wiring diagram (17) from bracket (15).
Remove clip halves (18) and insulation (19) from engine access door (6).
Remove assembled nuts (20), bolts (21), bracket (22), and holding rod (23) from engine access door (6).
Remove assembled nuts (24), bolts (25), and bracket (26) from engine access door (6).
Remove assembled nuts (27), screws (28), and latches (29) from engine access door (6).
Inspection.
Shut down generator set.
Inspect access doors, hinges, latches, and baffles for loose and missing hardware, cracks, dents, loose paint,
and corrosion.
Inspect data plates for readability, and loose or missing rivets.
Inspect insulation for tears, and missing clip halves.
Repair.
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surfaces in accordance with TM 43-0139. (F) Use applicable directives.
Replace unreadable data plates.
Replace loose or missing rivets.
Replace damaged insulation and missing clip halves. Refer to Appendix D for fabrication of insulation.
Replace damaged or missing cage nuts (30, FIGURE 2-5).
2-31
