ARMY TM 96115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
2-15.3. Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces CARC paint dust is a health
hazard and could cause personal injury if warning is not followed
a. Repair all dents and cracks, and remove all loose paint.
B. Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C)
c. Repaint surfaces in accordance with TM 43-0139 (F) Refer to applicable directives.
2-15.4. Installation.
a. Install ring (14, FIGURE 2-6) and bracket (13) on control box top panel (5) with bolts (11) and assembled nuts
(12).
b Install stiffener (10) in control box assembly with bolts (6), washers (7), lockwashers (8), and nuts (9).
NOTE
When replacing sealant with new gasket, ensure all old sealant residue is completely removed.
c. If gasket (15) was removed, install new gasket (15).
d. Immediately install top panel (5) with bolts (1), flatwashers (2), lockwashers (3), and assembled nuts (4).
e. Install control panel access door, paragraph 2-14.4.
f.
Connect negative battery cable. Close battery access door.
Change 4 2-35
