ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-2412
2-14 4. Installation.
a. Install latches (29, FIGURE 2-5) in right rear engine access door (6) with screws (28) and assembled nuts (27).
b. Install bracket (26) on engine access door (6) with bolts (25) and assembled nuts (24).
c. Install bracket (22) and holding rod (23) on engine access door (6) with bolts (21) and assembled nuts (20).
d. Install insulation (19) on engine access door (6) with clip halves (18).
e. Install wiring diagram (17) on bracket (15) with pop rivets (16).
f.
Install bracket (15) on air baffle (9) with bolts (12), lockwashers (13), and washers (14).
g. Install insulation (11) on air baffle (9) with clip halves (10).
h. Install air baffle (9) on engine access door (6) with bolts (8) and assembled nuts (7).
i.
Install right rear engine access door (6) and hinges (5) on generator set with bolts (3), washers (4), lockwashers
(2), and nuts (1).
j.
Close right side engine access doors.
2-15 CONTROL BOX TOP PANEL.
2-15.1. Removal.
a. Shut down generator set.
b. Open battery access door and disconnect negative battery cable.
c. Remove control panel access door, paragraph 2-14.1.
d. Lower control panel and remove bolts (1, FIGURE 2-6), flat-washers (2), lockwashers (3), and assembled nuts (4)
from top panel (5).
CAUTION
The control box top panel is attached to the generator set with a silicone sealant to prevent water
from entering the control box. Care must be taken not to bend or scratch the control box top
panel when separating.
e. Separate and remove control box top panel (5) by prying to break loose sealant.
f.
If damaged, remove gasket (15).
g. Remove bolts (6), washers (7), lockwashers (8), nuts (9), and stiffener (10) from control box assembly.
h. Remove bolts (11), assembled nuts (12), bracket (13), and ring (14) from control box top panel (5).
2-15.2. Inspection.
a. Shut down generator set.
b. Open battery access door and disconnect negative battery cable.
c. Inspect control box top panel (5, FIGURE 2-6) for dents, cracks, loose paint, and corrosion.
Change 4 2-33
